Brocade 1000BASE-BXD SFP optic, SMF, 1490 nm, LC connector
$0.00
Form Factor: SFP
Data Rate: 1Gb/s
Wavelength: TX-1490nm, RX-1310nm
Connector: LC Single mode
Cable Type: SMF
Reach Distance: 10km
Operating Temperature Range: 0°C to 70°C
Digital Optical Monitoring (DOM): Without
Applications: 1 Gigabit Ethernet
Only logged in customers who have purchased this product may leave a review.
The Cisco 1000BASE-T Gigabit Interface Converter (GBIC) is an ideal solution for Catalyst ® 6500, 4000, 3550, 2950, 3500 XL and 2900 XL Series switch customers, providing full duplex Gigabit Ethernet connectivity to high-end workstations and between wiring closets over existing copper network infrastructures. This GBIC technology leverages the industry’s flexible, standards-based 1000BASE-X design, allowing for a simple and low-cost migration path to Gigabit Ethernet. There are two key product applications for the Cisco 1000BASE-T GBIC: connectivity to high-end workstations and distribution and wiring closet interconnectivity.
HPE JH150A is a HP X132 10G SFP+ LC SR Transceiver. A 10-Gigabit transceiver in SFP+ form-factor that supports the 10-Gigabit SR standard, providing 10-Gigabit connectivity up to 300 m on multimode fiber.
The Cisco ® Coarse Wavelength-Division Multiplexing (CWDM) Gigabit Interface Converter (GBIC) solution allows enterprisecompanies and service providers to provide scalable and easy-to-deploy Gigabit Ethernet and Fibre Channel services in their networks.The product set helps enable the flexible design of highly available, multiservice networks.The Cisco CWDM GBIC solution is a convenient and cost effective solution for the adoption of Gigabit Ethernet and Fibre Channel in campus, data-center, and metropolitan-area access networks. The CWDM-GBIC-1570 is Cisco 1000BASE-CWDM 1570 nm GBIC.
GLC-LH-SM is the 1000BASE-LX/LH SFP for Both Multimode and Single-Mode Fibers. The 1000BASE-LX/LH SFP, compatible with the IEEE 802.3z 1000BASE-LX standard, operates on standard single-mode fiber-optic link spans of up to 10 km and up to 550 m on any multimode fibers. When used over legacy multimode fiber type, the transmitter should be coupled through a mode conditioning patch cable.
There are no reviews yet.